PROPERTIES

 

Easy placement:

 

  • Depending on the type of support: 

-Silicone.  

-Contact adhesive.

-Tail.

-Adhesive tape double sided.

-On sleepers (in case of being necessary for the condition of the wall).

-Velcro (it allows an easy disassembly to put in different place). 

  • It should be gived particular attention in the placement of models where the engraving of the drawings have a higher  relief
  • In case of risk of moisture or risk of leakage of water into the wall, we can supply the adhesive for the placement of the pieces.
  • Due to the process of tanning and the relief of the leather may be in a few zones thicker than in other one for what can exist small differences in the measures in some areas.
  • We recommend the installation with joint of 10 mm.
  • The placement of the coating can be with joint and without joint, we facilitate strips of leather to place between pieces.
  • For the placement combining different models we advise to place it exclusively with joint.
  • The singing of every piece remains completely redressed in leather, so the good ended one allows to place it with joint.  
  • The back of the piece is exempt of leather for the correct adherence to the wall.
  • It can be combined different thick.

 

 

Leather:

 

  • Handcrafted manufacture.
  • The manufacturing process is careful with the Environment. The tannery is ecological based on vegetable fibers, in no case is used chromium.
  • To the being a natural product there may be differences of color between pieces, even in the same piece.

 

 

Support coating:

 

  • Extruded foam with layer of reinforcement without cement and surface covered with geotextile.
  • Flat, stable and rigid.
  • Waterproof,temperature-resistant ·
  • Stops the step of water vapour.
  • Thermally insulating
  • It is possible to place on any type of support.
  • Quick and easy to placement.
  • Waterproof support of 30x30 cm.
  • With thick of 5,9,12.5, 19, 28, 38 and 50 mm. 

-Technical Information of support:

-Thermal conductivity DIN EN 12667 0,035 W/mK

-Thermal resistance from -58 ºF to 158 ºF (-50 °C to 75°C)

-Density of the material (rigid foam) DIN EN 1602 density 33 kg/m3

-Capacity of penetration of the water 0

-Coefficient of resistance to the diffusion of water vapour DIN EN 12086

-Thicknesses 5, 9, 12,5 mm µ = 1550

-Thicknesses 19, 28, 38, 50 mm µ = 440

-Coefficient of linear thermal expansion 0,007 mm/mK